The MSR μGard®2 MC2 chlorine gas detector (4-20 mA / 2-10 V transmitter) monitors chlorine continuously in water treatment plants, swimming pools and chlorination rooms. Its electrochemical sensor measures from 0-10 up to 0-20 ppm. It sends a linear 4-20 mA or 2-10 V signal to a gas controller, BMS or PLC.

Why choose the MC2 chlorine gas detector

  • Calibration data is stored in the sensor head. A pre-calibrated head can be swapped on site, without bringing test gas to site.
  • Digital signal processing with temperature compensation gives stable readings.
  • 3-wire, 24 V DC, protected against reverse polarity and short circuits.
  • Choose a sensor head only, a compact D housing, or an IP65 A housing. The A housing is also available with a display and 2 open-collector outputs for a horn and warning lamp.
  • Works with PolyGard®2 controllers and sensor boards.

Chlorine gas detector specifications

Gas Chlorine (Cl2)
Measuring ranges 0-10 or 0-20 ppm
Sensor Electrochemical
Output 4-20 mA or 2-10 V, 3-wire
Supply 24 V DC
Housing options Sensor head only; type D (94 x 65 x 57 mm); type A (94 x 130 x 57 mm, IP65), also with display
Operating temperature -30 to +50 °C
Expected sensor life > 2 years
Calibration interval 6 months
Mounting height 0.3-0.5 m above the floor (chlorine is heavier than air)

Calibration and service

Gas Alarm calibrates and services MSR gas detectors through its service teams in NSW, SA and VIC. We recommend calibrating every 6 months, or sooner after a gas leak or high exposure.

Ordering

Part numbers start with MC2-0 (sensor head only), MC2-D (D housing) or MC2-A (A housing). Tell us the measuring range, housing and output you need, and we’ll quote the exact part number.

Datasheet (PDF)